No products in the cart.
YF-S403 3/4″ Water Flow Hall Sensor 3/4 Inch External Thread 1-30L/min Flowmeter
Roll over image to zoom in
₹625.00₹699.00 (-11%)
Water flow sensor mainly consist of plastic valve, water flow rotor assembly and Holzer sensor. The rotation of the magnetic rotor and the rotating speed change with the change of the flow rate, and the output of the Holzer sensor is corresponding to the pulse Signal, feedback to the controller, by the controller to determine the size of the water flow, control.
It is installed in the hot water inlet end for detecting water flow. When water through the flow rotor assembly, magnetic rotor will rotate and Speed will change as the flow change. Hall current sensor output corresponding pulse signal and feedback to controller, then the controller will control the flow. Can be used for water heaters, credit card machines, water vending machine, flow measurement device.
Features:
- Light weight, small size, easy to install.
- Inlaid with stainless steel impeller shaft, durable wearable.
- Seal ring with the upper and lower force structure never leaks.
- Non-violent shock, and chemical erosion.
- Non-throwing or hitting.
- Mounted vertically, should not exceed 5 degrees inclination.
- Temperature of medium should not exceed 120 ℃.
Wire Connections:
- Red: Positive(+)
- Yellow: Signal output.
- Black: Negative(-)
Product Applications
This product can be used in water heating systems, automatic water dispenser and other flow metering equipment
Lowest rated working voltage | DC 4.5 5V - 24V. |
Maximum Operating Current | 15 mA (DC 5V). |
Working voltage range | DC 5 - 18V. |
Load capacity | ≤ 10 mA (DC 5V). |
Working temperature | ≤ 80 ℃ |
Working humidity range | 35%-90% RH (no frost) |
Allow Pressure | 1.75Mpa |
Storage temperature | -25 - + 80 ° c |
Save Humidity | 25% - 95% RH |
Flow range | 1-30L / min |
External thread | Â 3/4 " |
Size | Approx 6.2 * 3.5 * 4.1 cm |
Output interface diameter | Ca. Outside 26mm, inside 12mm, 14mm. |
Reviews
There are no reviews yet.