No products in the cart.
3.5 inch TFT Touch Screen Display for Arduino
Roll over image to zoom in
₹1,095.00₹1,289.00 (-15%)
3.5 inch TFT Touch Screen Display for Arduino is big (3.5″ diagonal) bright and colorful! 480×320 pixels with individual RGB pixel control, this has way more resolution than a black and white 128×64 display, and double our 2.8″ TFT.
As a bonus, this display has a resistive touchscreen sensor allowing you to control your application simply by touching any area of the screen. This display has a controller built into it with RAM buffering so that almost no work is done by the microcontroller.
Features :
- 3.5-inch color screen,support 65K color display,display rich colors
- 480X320 resolution, optional touch function
- Using the SPI serial bus, it only takes a few IOs to illuminate the display
- Easy to expand the experiment with SD card slot
- Provide a rich sample program
- Military-grade process standards, long-term stable work
- Provide underlying driver technical support
Specifications:
Name | Parameter |
Display Color | RGB 65K color |
Screen Size | 3.5(inch) |
Type | TFT |
Driver IC | ILI9488 |
Resolution | 480*320 (Pixel) |
Module Interface | 4-wire SPI interface |
Active Area (AA area) | 48.96x73.44(mm) |
Module PCB Size | 56.34x98(mm) |
Operating Temperature | -20℃~60℃ |
Storage Temperature | -30℃~70℃ |
VCC power voltage | 3.3V~5V |
Logic IO port voltage | 3.3V(TTL) |
Rough Weight(Package containing) | No touch: 45 (g) / With touch: 57 (g) |
Package Includes :
-
- 1 x 3.5″ Inch TFT Touch Screen Module
Number | Pin Label | Description |
1 | VCC | 5V/3.3V power input |
2 | GND | Ground |
3 | CS | LCD chip select signal, low level enable |
4 | RESET | LCD reset signal, low level reset |
5 | DC/RS | LCD register / data selection signal,
high level: register, low level: data |
6 | SDI(MOSI) | SPI bus write data signal |
7 | SCK | SPI bus clock signal |
8 | LED | Backlight control, high level lighting,
if not controlled, connect 3.3V always bright |
9 | SDO(MISO) | SPI bus read data signal, if you do not need to the read function, you can not connect it |
(The following is the touch screen signal line wiring, if you do not need to touch function or the module itself does not have touch function, you can not connect them) | ||
10 | T_CLK | Touch SPI bus clock signal |
11 | T_CS | Touch screen chip select signal, low level enable |
12 | T_DIN | Touch SPI bus input |
13 | T_DO | Touch SPI bus output |
14 | T_IRQ | Touch screen interrupt signal, low level when touch is detected |
Reviews
There are no reviews yet.